Kb-electronics Multi Speed Board User Manual download pdf (Page 11)

Note: All jumpers on

the KBMG must be set

before installing the KBMG

finger-safe cover.

E. Installing the KBMG Multi-

speed Board onto the

KBMG – The terminal block

located on the bottom of

the KBMG Multi-Speed

Board plugs onto the six (6)

header pins where TB1 was

removed from the KBMG.

The two (2) holes on the

back of the KBMG Multi-

Speed Board snap onto the

finger-safe cover. Use the

two (2) 6-32 X 1

⁄4” screws,

that were previously

removed, to secure the

KBMG Multi-Speed Board

to the KBMG. Do not over

tighten these screws or

damage may result to the

KBMG Multi-Speed Board and the KBMG. See Figure 7, on page 6.

Installation is now complete.

KBMG Finger-Safe Cover. Remove Panel

(cut 7 places) to Install KBMG Multi-Speed Board.

FIGURE 10 – REMOVING KBMG FINGER-SAFE

COVER PANEL

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Kb-electronics Multi Speed Board User Manual Page 11